M82 and M82A1 Percussion Primers

This Statement of Work (SOW) replaces all previous contract requirements concerning COCO facilities. The information is an extract from DoD M 5100.76, Department of Defense Physical Security of Sensitive Conventional Arms, Ammunition and Explosives. The intent is to provide COCO facilities an easy reference. This SOW was prepared by the Physical Security Office of the US Army Joint Munitions Command, Command Provost Marshal for Operations G2/6 (Protection Division), Rock Island Arsenal, Rock Island, IL 61299-6000. SECURITY STATEMENT OF WORK (SOW) PHYSICAL SECURITY STANDARDS FOR DOD SECURITY RISK CATEGORY (SRC) ARMS, AMMUNITION AND EXPLOSIVES (AA&E) CONTRACTOR-OWNED AND CONTRACTOR-OPERATED (COCO) FACILITIES Paragraph/Title: Page: 1. General 2 2. Contractor-Owned AA&E Production and Storage Facilities 2 3. Facility Construction 2 4. Contractor Facility Suitability Determination 3 5. Additional Protective Measures 4 6. AA&E Production Line Security 8 7. In-Transit Security 8 8. Classified AA&E 8 9. Accountability 8 10. Disposal and DEMIL of AA&E 9 11. Arms Parts 9 12. Incident Reports 9 13. Physical Security Deviations 10 14. Standing Practices Procedures 11 Appendix: I – AUTHORITY AND CONTRACT CLAUSES RELATING TO DOD AA&E 12 II – SENSITIVE CONVENTIONAL AA&E SRC 14 III – REQUEST FOR SECURITY WAIVERS AND EXCEPTIONS 20 -- 1 of 20 -- HQ JMC G 2/6 Protection 6 Jan 2025 Subject: DoD Security Standards for SRC AA&E (COCO Sites) This Statement of Work (SOW) replaces all previous contract requirements concerning COCO facilities. The information is an extract from DoD M 5100.76, Department of Defense Physical Security of Sensitive Conventional Arms, Ammunition and Explosives. The intent is to provide COCO facilities an easy reference. This SOW was prepared by the Physical Security Office of the US Army Joint Munitions Command, Command Provost Marshal for Operations G2/6 (Protection Division), Rock Island Arsenal, Rock Island, IL 61299-6000. 2 1. GENERAL. AA&E in the custody of contractor owned facilities shall be protected according to the provisions of this Statement of Work (SOW) through the express terms of the contract. Any additional requirements imposed by a DoD procuring command or activity shall be specified in section H, “Special Clauses Section,” of the contract. Additional AA&E Physical Security requirements, if deemed required, shall be provided to the DoD OUSD (I) Director of Security by the procuring command or activity. 2. CONTRACTOR-OWNED AA&E PRODUCTION AND STORAGE FACILITIES. These facilities include areas where, through contract with the DoD components, arms, ammunition and/or explosives are manufactured, retrofitted, modified, or developed. This SOW provides the physical security requirements that apply specifically to contractor-owned facilities. In addition to this SOW, all other requirements in DoD 6055.09-M, DoD Ammunition and Explosives Safety Standards, February 29, 2008 applicable to the SRC of AA&E being controlled, stored, or otherwise in the control of the contractor shall be applied. 3. FACILITY CONSTRUCTION. AA&E in production and/or storage at contractor- owned facilities shall be secured in one of the structures listed in subparagraphs 3.a. through 3.i. of this SOW as prescribed and authorized by the procuring command or activity: a. A structure built in accordance with DoD 6055.09-M, DoD Ammunition and Explosives Safety Standards, February 29, 2008. b. A structure that complies with DoD 4145.26-M, DoD Contractor’s Safety Manuel for Ammunition and Explosives, March 13, 2008. c. A portable explosives magazine as specified in Naval Facilities Engineering Service Center Technical Data Sheet TDS-2078-SHR, Pre-engineered Explosives Magazines, June 2001. d. A structure built according to the procuring command or activity’s applicable Military Department or Unified Facilities Criteria (UFC) construction requirements for AA&E as supplemented by guidance in this Manual. e. A storage structure built in accordance with Military Handbook 1013/1A, Design Guidelines for Physical Security of Facilities, December 15, 1993 to meet appropriate threat and delay time requirements. -- 2 of 20 -- HQ JMC G 2/6 Protection 6 Jan 2025 Subject: DoD Security Standards for SRC AA&E (COCO Sites) This Statement of Work (SOW) replaces all previous contract requirements concerning COCO facilities. The information is an extract from DoD M 5100.76, Department of Defense Physical Security of Sensitive Conventional Arms, Ammunition and Explosives. The intent is to provide COCO facilities an easy reference. This SOW was prepared by the Physical Security Office of the US Army Joint Munitions Command, Command Provost Marshal for Operations G2/6 (Protection Division), Rock Island Arsenal, Rock Island, IL 61299-6000. 3 f. An existing structure if approved by the procuring command or activity. The procuring command or activity shall coordinate with the supporting DSS field office for those facilities approved for use by the procuring command or activity. The procuring command or activity shall ensure alternative or compensatory measures are implemented prior to approval of existing structures that are not compliant with this Manual. The procuring command or activity shall maintain a list and provide a copy to the DSS supporting field office. g. A GSA-approved modular vault according to Federal Specification AA-D-D Vault System, May 15, 2000, superseding AA-D-00600C, December 1, 1990. h. A GSA-approved Class 5 map and plan container according to Federal Specification AA-F-363D, Filing Cabinet, Security, Maps and Plans, General Filing, and Storage, June 1, 2001 and AMENDENT 4, April 6, 2015, AA-F-358K, Filing Cabinet, Legal and Letter Size, Uninsulated, Security, February 16, 2023, or GSA-approved Class 5 weapons storage container according to Federal Specification AA-C-2859A, Cabinet, Security, Weapons Storage, April 20, 2007, for storage of SRC III and IV arms only. i. A Type…