Skip to content

Open for responses

FA27 Fall Arrest Inspection Services

DEPT OF DEFENSE

Notice type
Sources Sought
Solicitation #
FA462026QA303
NAICS
561210
PSC
H342
Set-aside
Small Business Set Aside - Total
Posted
November 4, 2026
Response due
November 26, 2026
Place of performance
Fairchild AFB, WA

What this opportunity is

The Department of Defense is seeking small businesses to provide Fall Arrest System Inspection Services under NAICS 561210. This sources sought notice is aimed at identifying potential vendors for future contracting opportunities, but it is not a solicitation and does not request pricing information. Interested small businesses should note that responses will not be considered for contract award and must be registered with the System for Award Management (SAM) to participate in any resulting solicitation.

Analysis by Mindy, grounded in the SAM.gov notice.

Description

STATEMENT OF WORK FALL ARREST SYSTEM INSPECTION Fairchild Air Force Base, Washington DESCRIPTION OF WORK. Contractor shall perform annual inspections of the fall protection systems located in building 2050 hangars No. 1, 2, 3, & 4 located at Fairchild AFB, Washington. Building 2050 is located in a controlled area. Escorts will be provided by the government as coordinated in advance to perform services. Non-U.S. citizen workers are prohibited from accessing the controlled area. The annual inspection shall be performed in accordance with all federal, state, local regulations and manufacturer recommendations. The inspection is necessary to ensure continued compliance with OSHA Regulations and manufacturer recommendations. The contractor shall provide an 85-foot lift to access the system. As a minimum the inspection shall consist of the following actions:  A hands on inspection of all components of the installed system  Visually verify all end terminations  Tighten all lock nuts to the required torque  Inspect for presence of cotter pins where appropriate  Check for damage to all components including cable along its entire length, intermediate brackets and end termination  Inspect intermediate brackets for excessive deformation  Perform minor repairs as needed  Photo document any in-depth repairs that may be required  Inspect user equipment supplied with the original system or replacement of same make and model, including harnesses and lanyards.  Perform all other actions required to comply with OSHA and/or manufacturer’s inspection requirements. The inspection will be limited to the engineered system components installed by Evan Corporation or manufactured by Capital Safety Group and installed by others. At the completion of the inspection, the contractor shall issue a written report attesting to the condition of the system and its conformance with OSHA Regulations. The report shall include an estimate for any repairs that may be required. OPERATIONS SECURITY (OPSEC) REQUIREMENTS. The contractor will protect critical and/or sensitive information from disclosure. The DoD contractor will: 1. Be familiar with their organization’s critical information. When publicly posting or publishing work- related information that potentially contains critical or sensitive information airmen are encouraged to solicit the advice of their immediate supervisor, security office and/or OPSEC Program Manager/Coordinator. 2. Consider attempts by unauthorized personnel to solicit critical and/or sensitive information as human intelligence (HUMINT) gathering and consider it a HUMINT incident. Contract personnel who have been involved in or have knowledge of a possible incident will report all facts immediately to the nearest supporting Air Force Office of Special Investigations (AFOSI) office. 3. If AFOSI is not readily available, HUMINT incidents will be reported to the organization’s security manager or commander who will ensure that, without exception, reports are relayed as securely and expeditiously within 24 hours to the nearest AFOSI organization. FA462020P0063 Attachment 1 Page 1 of 2 -- 1 of 18 -- HOURS OF OPERATION. The normal hours of operation are 0800-1700, Monday-Friday excluding federal holidays. The following federal holidays are observed: January 1 New Years Day 3 rd Monday in January Martin Luther King, Jr. Day 3 rd Monday in February President’s Day Last Monday in May Memorial Day July 4 Independence Day 1 st Monday in September Labor Day 2 nd Monday in October Columbus Day November 11 Veterans Day 4 th Thursday in November Thanksgiving Day December 25 Christmas ATTACHMENTS: 1. Inspection Criteria FA462020P0063 Attachment 1 Page 2 of 2 -- 2 of 18 -- -- 3 of 18 -- -- 4 of 18 -- -- 5 of 18 -- -- 6 of 18 -- -- 7 of 18 -- -- 8 of 18 -- -- 9 of 18 -- -- 10 of 18 -- -- 11 of 18 -- -- 12 of 18 -- -- 13 of 18 -- -- 14 of 18 -- Inspection, Care & Maintenance Horizontal Lifelines Frequency: Visually inspect anchors and connectors before each use in accordance with manufacturer's instructions. Damaged systems and components must be removed from service immediately. In the event of a fall, the system must be removed from service, inspected, repaired and recertified for use by Evan Corporation. Inspect system components for: • Excessive corrosion, dents, cracks, fraying and deformities. • Check end anchor fasteners and intermediate brackets (end anchors must be torqued at 75 ft.lbs. and intermediate brackets at 18 ft.lbs.). • Check site label(s) making sure they are present, legible, and secured near an access location. • Inspect User Equipment per associated manufacturer's instructions. Check connecting means for wear or deformities. 17 FA462020P0063 SOW Attachment 1 Page 10 of 13 -- 15 of 18 -- FA462020P0063 SOW Attachment 1 Page 11 of 13 -- 16 of 18 -- Inspection, Care & Maintenance Rigid Rail - Enclosed Track and Wide Flange Beams • Check site label(s) making sure they are present, legible, and secured near an access location. • Inspect system prior to each use as per ANSI. • Inspect User Equipment per associated manufacturer's instructions. • Refer to the instructions supplied with the harness, lanyard and self-retracting lifeline for cleaning and servicing pro cedures. Store the harness, lanyard or self-retracting lifeline in a cool, dry clean environment and out of direct sunlight. • In the event of a fall, the system must be removed from service until it is inspected and approved for us.e. FA462020P0063 SOW Attachment 1 Page 12 of 13 -- 17 of 18 -- FA462020P0063 SOW Attachment 1 Page 13 of 13 -- 18 of 18 --

Source: SAM.gov, as posted. Verify the current solicitation before responding.

Pursue this opportunity with Mindy

See who holds it now, who else is bidding, and draft your response — grounded in real government data, not generic AI.

View the original notice on SAM.gov ↗

Open opportunities in NAICS 561210