Ft. Bliss Kitchenette Remodeling - BLDG 2447

DEPT OF DEFENSE

Notice type
Solicitation
Solicitation #
W911RX26BA006
NAICS
236220
PSC
Z2FC
Set-aside
Total Small Business Set-Aside (FAR 19.5)
Posted
June 25, 2026
Response due
July 28, 2026
Place of performance
Fort Bliss, TX

What this opportunity is

The Department of Defense is buying kitchenette remodeling services for BLDG 2447 at Ft. Bliss in Texas, classified under NAICS code 236220. This opportunity is set aside for total small businesses. As a solicitation notice, small businesses should track this opportunity to prepare for a potential bid.

Analysis by Mindy, grounded in the SAM.gov notice.

Description

E N C O N International, Inc. Engineering, Environmental, & Technical Services June 23, 2008 Mr. Henry Wilson Phone: (915) 568-2300 Asbestos & Lead Manager Fax: (915) 568-4304 DPW, Bldg. 777 Fort Bliss, TX 79916 RE: SUBMITTAL OF ASBESTOS & LEAD SURVEY REPORTS Ft. Bliss Bldg. # 2447 ENCON Project #103-08-094 Dear Mr. Wilson, This document summarizes the Asbestos & Lead Survey Report for the subject facility. The below-listed information was utilized to complete the Scope of Work Tasks: Project Location and/or Room No. Whole Bldg. Brief SOW: Performed sampling prior to demolition or renovation activities. ASBESTOS – The sample collection and subsequent laboratory analytical results indicated that asbestos was not identified in the sampled building materials. LEAD – Results indicate that twenty-six (26) of the one hundred fifty-two (152) XRF readings tested at or above the limit of 0.3 mg/cm2 Technical Summary Were Found Were Not Found Not Tested 1. Asbestos Containing Materials (>1 %) X 2. Lead Based Paint Materials X Contact me with any technical questions, or follow-up needs that you may have. Sincerely: Alex Woelper P.E. Project Manager Attachments:  Asbestos & Lead Survey Reports -- 1 of 40 -- El Paso Office: 7307 Remcon Circle, Suite 103  El Paso, Texas 79912  Fax 915-581-2049  Phone 915-833-3740 Engineering, Environmental & Technical Services ASBESTOS SURVEY REPORT BUILDING 2447 FORT BLISS, TEXAS 79916 Prepared for: Mr. Henry Wilson, P.E. DPW Building 777 Fort Bliss, Texas 79916 Prepared by: ENCON International, Inc. 7307 Remcon Circle, Suite 103 El Paso, Texas 79912 Date of Inspection: June 12, 2008 ENCON Project No. 103-08-094 E N C O N INTERNATIONAL, INC. -- 2 of 40 -- Engineering, Environmental & Technical Services June 17, 2008 Mr. Henry Wilson, P.E. Phone: (915) 568-2300 Asbestos & Lead Manager Via email & hand delivery DPW, Bldg. 777 Fort Bliss, TX 79916 RE: ASBESTOS SURVEY REPORT Building 2447 Fort Bliss, TX 79916 Dear Mr. Wilson, ENCON International, Inc., (ENCON) has submitted for your review the attached Asbestos Survey Report. This Asbestos Survey was conducted in accordance with Asbestos National Emissions Standards for Hazardous Air Pollutants (NESHAP): 40 CFR Part 61, Subpart M. Sampling protocols were performed in accordance with the Texas Asbestos Health Protection Rules (TAHPR). This Asbestos Survey was properly performed by ENCON DSHS licensed personnel. ENCON’s personnel have been trained and are in compliance with Texas Department of State Health Services (DSHS) regulations. If you have any questions regarding this Asbestos Survey, please feel free to contact us at your convenience. Sincerely, Alex Woelper, P.E. Program Manager Attachments:  Asbestos Survey Report  Asbestos Drawings  Photo Log  Laboratory Documentation E N C O N INTERNATIONAL, INC. -- 3 of 40 -- Asbestos Survey Report ENCON International, Inc. Ft. Bliss, Bldg. 2447 Project No. 103-08-094 Page 1 El Paso Office: 7307 Remcon Circle, Suite 103  El Paso, Texas 79912  Fax 915-581-2049  Phone 915-833-3740 ASBESTOS SURVEY REPORT Ft. Bliss, Bldg. 2447 SUMMARY ENCON International, Inc. (ENCON) personnel performed an Asbestos Inspection of a structure designated as “Building 2447” on Fort Bliss, Texas. The following are the field sample collection and analysis results for this inspection. The inspection was conducted to ensure compliance with NESHAP – 40 CFR Part 61, Subpart M, which states that “prior to the commencement of the demolition or renovation, thoroughly inspect the affected facility or part of the facility where the demolition or renovation operation(s) will occur for the presence of asbestos, including Category I and Category II non-friable ACM. ” The sample collection and subsequent laboratory analytical results indicated that asbestos was not identified in the sampled building materials. INTRODUCTION This Asbestos Survey was performed by Mr. David Morales on June 12th, 2008. This Asbestos Survey was conducted in accordance with Asbestos National Emissions Standards for Hazardous Air Pollutants (NESHAP): 40 CFR Part 61, Subpart M. Sampling protocols were performed in accordance with the Texas Asbestos Health Protection Rules (TAHPR). Building 2447 was to undergo renovations and was visually inspected and it was determined that the suspect asbestos- containing materials could be divided into thirty (30) homogeneous areas, including the following: rubberized flooring mastic (3 types), cove base mastic (9 types), textured drywall/joint compound (8 types), 12” x 12” floor tile & mastic (3 types), carpet mastic (4 types), 2’ x 4’ ceiling panels (2 types), and textured stucco. DESCRIPTION Building 2447 was being used as military personnel housing on Fort Bliss, Texas. The building occupied approximately 38,000 SF. The building was a three-story structure constructed with -- 4 of 40 -- Asbestos Survey Report ENCON International, Inc. Ft. Bliss, Bldg. 2447 Project No. 103-08-094 Page 2 El Paso Office: 7307 Remcon Circle, Suite 103  El Paso, Texas 79912  Fax 915-581-2049  Phone 915-833-3740 CMU walls on a concrete foundation. The interior was partitioned with drywall walls. The floor was covered with floor tile and carpeting. At the time this Asbestos Survey was performed, the date of construction was not known. SAMPLING METHODOLOGY A visual inspection of the building was conducted to develop a sampling plan. This included determining sample collection points, homogeneous materials and areas. Friability was assessed by manually manipulating the suspect asbestos materials utilizing hand pressure to determine if the materials, when dry, can be crumbled, pulverized, or reduced to powder. Thirty (30) homogeneous areas were established and at least three (3) samples were collected from each area. Areas that have suspect asbestos-containing surfacing, thermal systems insulation, or miscellaneous materials are to be considered homogeneous. These samples were each uniquely and individuall

Source: SAM.gov, as posted. Verify the current solicitation before responding.

Pursue this opportunity with Mindy

See who holds it now, who else is bidding, and draft your response — grounded in real government data, not generic AI.

View the original notice on SAM.gov ↗

Similar Active Opportunities (NAICS 236220)