Description
DISTRIBUTION STATEMENT A. Approved for public release. Distribution unlimited
MIL-DTL-4088L
1 April 2021
SUPERSEDING
MIL-W-4088K
21 November 1988
DETAIL SPECIFICATION
WEBBING, TEXTILE, WOVEN NYLON
This specification is approved for use by all Departments and Agencies of the Department of
Defense (DoD).
1. SCOPE
1.1 Scope. This specification covers woven nylon, textile webbing.
1.2. Classification. The nylon webbing will be available in the types and classes as specified
(see 6.2). The types will conform to the requirements as specified in Table IV and V as
applicable for the class specified.
1.2.1 Classes.
Class 1 - Shuttle loom, nylon 6,6
Class 1A - Shuttleless loom, nylon 6,6
Class 2 - Shuttle or shuttleless loom, nylon 6 or nylon 6,6
1.2.1.1 Class reference. When procurement documents referencing this specification do not
specify the class of webbing, any class in paragraph 1.2 may be used.
Comments, suggestions, or questions on this document should be addressed: ATTN: DLA
Troop Support, 700 Robbins Avenue, Philadelphia, PA 19111-5096. Since contact
information can change, you may want to verify the currency of the address information using
Acquisition Streamlining and Standardization Information System (ASSIST) online database
https://assist.dla.mil
AMSC N/A FSC 8305
2. APPLICABLE DOCUMENTS
INCH-POUND
Source: https://assist.dla.mil -- Downloaded: 2021-04-21T14:51Z
Check the source to verify that this is the current version before use. Copyright DLA Troop Support - Clothing & Textile Items of SupplyProvided by Accuris Licensee=Joint Munitions Command (JMC)-Pine Bluff Arsenal/5974512041, User=Fritsche, MatthewNot for Resale, 05/06/2025 07:29:27 MDT No reproduction or networking permitted without license from Accuris
--``,,,`,,,,`,`,````,,,``,`,,,`,-``,,`,,,,-``,,`,,,,---
-- 1 of 26 --
MIL-DTL-4088L
2
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2. Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise
specified, the issues of these documents are those cited in the solicitation or contract.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-1480 - Color Codes for Webbing, Textile; Manufacturers Identification
MIL-STD-3064 - Evaluation of Quality of Textile Materials
(Copies of these documents are available online at https://quicksearch.dla.mil.)
2.2.2 Other government documents, drawings, and publications. The following other
Government documents, drawings, and publications form a part of this document to the extent
specified herein. Unless otherwise specified, the issues are those cited in the solicitation or
contract.
FEDERAL TRADE COMMISSION
Rules and Regulations Under the Textile Fiber Products Identification Act
(Copies of this document are available online at https://www.ftc.gov.)
2.3 Non-government publications. The following documents form a part of this document to
the extent specified herein. Unless otherwise specified, the issues of these documents are those
cited in the solicitation or contract.
COLOR ASSOCIATION OF THE UNITED STATES (CAUS)
(Copies of this document are available at https://www.colorassociation.com.)
AMERICAN ASSOCIATION OF TEXTILE CHEMISTS AND COLORISTS (AATCC)
AATCC EP1 - Evaluation Procedure for Gray Scale for Color Change
AATCC EP2 - Evaluation Procedure for Gray Scale for Staining
AATCC EP8 - Evaluation Procedure for AATCC 9-Step Chromatic Transference Scale
AATCC EP9 - Evaluation Procedure for Visual Assessment of Color Difference of
Textiles
Source: https://assist.dla.mil -- Downloaded: 2021-04-21T14:51Z
Check the source to verify that this is the current version before use. Copyright DLA Troop Support - Clothing & Textile Items of SupplyProvided by Accuris Licensee=Joint Munitions Command (JMC)-Pine Bluff Arsenal/5974512041, User=Fritsche, MatthewNot for Resale, 05/06/2025 07:29:27 MDT No reproduction or networking permitted without license from Accuris
--``,,,`,,,,`,`,````,,,``,`,,,`,-``,,`,,,,-``,,`,,,,---
-- 2 of 26 --
MIL-DTL-4088L
3
AATCC TM8 - Test Method for Colorfastness to Crocking: Crockmeter
AATCC TM16.3 - Test Method for Colorfastness to Light: Xenon Arc
AATCC TM20 - Test Method for Fiber Analysis: Qualitative
AATCC TM61 - Test Method for Colorfastness to Laundering: Accelerated
AATCC TM81 - Test Method for pH of the Water-Extract from Wet Processed Textiles
(Copies of these documents are available online at https://www.aatcc.org.)
AMERICAN SOCIETY FOR QUALITY
ASQ/ANSI Z1.4 – Sampling Procedures and Tables for Inspection by Attributes
(Copies of this document are available online at https://asq.org.)
ASTM INTERNATIONAL
ASTM D1423/D1423M - Standard Test Method for Twist in Yarns by Direct-Counting
ASTM D1776/D1776 - Standard Practice for Conditioning and Testing Textiles
ASTM D1777 - Standard Test Method for Thickness of Textile Materials
ASTM D1907/D1907M - Standard Test Method for Linear Density of Yarn (Yarn
Number) by the Skein Method
ASTM D3774 - Standard Test Method for Width of Textile Fabric
ASTM D3775 - Standard Test Method for End (Warp) and Pick (Filling)Count
of Woven Fabrics
ASTM D3776/D3776M - Standard Test Methods for Mass Per Unit Area (Weight) of
Fabric
ASTM D6770 - Standard Test Method for Abrasion Resistance of Textile Webbing
(Hex Bar Method)
ASTM D6775 - Standard Test Method for Breaking Strength and Elongation of
Textile Webbing, Tape and Braided Material
(Copies of these documents are available online at https://ww…
Source: SAM.gov, as posted. Verify the current solicitation before responding.