Skip to content

Open for responses

Grease Traps Maintenance - Dover AFB

DEPT OF DEFENSE

Notice type
Combined Synopsis/Solicitation
Solicitation #
FA449727Q0009
NAICS
562998
PSC
S222
Set-aside
Small Business Set Aside - Total
Posted
November 10, 2026
Response due
November 25, 2026
Place of performance
Dover AFB, DE

What this opportunity is

The Department of Defense is seeking Grease Trap Maintenance Services at Dover Air Force Base, Delaware, under NAICS code 562998, which is set aside for small businesses. This requirement involves providing management, tools, supplies, and labor to clean and maintain grease traps, ensuring compliance with EPA and state regulations. Interested small businesses should note that this is a combined synopsis/solicitation, meaning they must submit quotes by the specified deadline rather than waiting for a formal solicitation to be issued.

Analysis by Mindy, grounded in the SAM.gov notice.

Description

PERFORMANCE WORK STATEMENT FOR MAINTENANCE OF GREASE TRAPS Dover AFB 7 October 2026 -- 1 of 14 -- PERFORMANCE WORK STATEMENT FOR MAINTENANCE OF GREASE TRAPS 1. DESCRIPTION OF SERVICES. The contractor shall provide all management, tools, supplies, equipment, and labor necessary to clean and maintain grease traps located at Dover Air Force Base, Delaware. Work shall be performed in accordance with standard commercial practices, and in compliance with current Environmental Protection Agency (EPA) and State of Delaware Department of Natural Resources and Environmental Control (DNREC) requirements. This will include removal from the base the resulting gray water, fats, oils, grease, and solids (FOGS) in accordance with standard commercial practices. The Contractor shall submit a planned work schedule for the entire year to the COR according to the established trap cleaning intervals found on Appendix A for approval no later than 10 calendar days after contract award. Each out year of the contract will also require a planned work schedule submitted 10 days after award. See attached list on Appendix A for location, size, and frequency of cleaning of grease traps. 1.2. DESCRIPTION OF WORK. Remove waste built up from grease traps or pit walls and all associated equipment within the pit with water pressure washer equipment. Flush down with water and pump out remaining residue as required by the unique configuration of each grease trap. Residual or recharged water must be higher than lower inlets. Clear any obstructions in inlet/outlet pipes to ensure unrestricted flow. Transport all materials from grease traps to an approved off-base storage facility. The Contractor shall clean the surface area around the grease trap to be free of grease and food particles. The contractor shall correct any spills, splashes, or damages caused by the Contractor’s operation. Spillage onto floors and ground will be cleaned by the Contractor. The Contractor shall provide an inspection report/service ticket to the COR after work is complete and prior to leaving the base. The service ticket shall have the company letterhead along with facility number, condition of the trap, estimated gallons pumped, and any structural condition or safety issues. The report shall have the date, time and signature of employee conducting the work. The COR’s office is located in facility 615 of the 436th Civil Engineer Squadron Service Contracts section. 1.3. EMERGENCY SERVICE CALLS. Unexpected services may be required in the event of excessive grease buildup or flow restriction in the trap or other unscheduled repairs to pipes or other infrastructure involving grease traps. In the event that emergency service is required outside the contractor’s approved schedule, the contractor shall provide a telephone response to the emergency service request within two hours and begin the service within four hours after the government makes the initial call or request. The contractor shall provide a personnel list to identify key personnel with cell phone or pager numbers for emergency response calls. The contractor shall submit changes to the list immediately as employees begin or stop work under the contract. 1.4. SAFETY AND HEALTH STANDARDS. The contractor shall initiate and maintain programs to comply with the provisions of the Occupational Safety and Health Standards Act concerning entry requirements in confined spaces and handling potential hazardous substances. The Contractor shall comply with the State of Delaware Department of Natural Resources and Environmental Control (DNREC) laws and regulations for Solid Waste Management and Water -- 2 of 14 -- Quality Control and Sanitary Code for Kent County, Delaware. The Contractor shall not discharge anything into the sanitary sewer system. 1.4.1 Safety Requirements. In performing any work under this contract on premises which are under the direct control of the Government, the Contractor shall conform to all safety rules and requirements prescribed in Air Force Pamphlet 91-210, Contract Safety and Public Law 91-596 and the Occupational Safety and Health Act of 1970. Effective on the date of this contract, the contractor shall take such additional precautions as the Contracting Officer may reasonably require for security, safety, traffic, fire, personnel clearances, and accident prevention purposes. The Contractor agrees to take all reasonable steps and precautions to prevent accidents and preserve the life and health of the Contractor, Government Property and Government personnel performing or in any way coming in contact with the performance of this contract on such premises. These requirements are additional too and do not replace the standards promulgated by the Department of Labor under the Occupational Safety and Health (OSHA) Act. In the event of a conflict between the OSHA Standards and these requirements, the most stringent shall apply. Any violation of such rules and requirements, unless promptly corrected, as directed by the Contracting Officer, may be considered grounds for termination of this contract in accordance with the default provisions hereof. 2. SERVICE SUMMARY. Performance Objective SOW Para Performance Threshold Clean and Maintain Grease Traps. Initial check documented. Document all safety hazards on traps during inspections. Remove and properly dispose of fats, oils, greases and solids (FOGS). Clean all grease traps and maintain proper water level in trap. Maintain grease traps to prevent no more than 25% of grease trap filled with FOGS. 1.1, 1.2, 1.3 No more than 3 customer complaints per service month. Emergency Service Calls. Emergency service technician shall respond and be on site within two hours from notification. 1.3. No deficiencies permitted. 3. GOVERNMENT FURNISHED PROPERTY AND SERVICES. All reasonable quantities of utilities will be made available to the Contractor without charge. Any temporary connections and lines needed will be installed, ma…

Source: SAM.gov, as posted. Verify the current solicitation before responding.

Pursue this opportunity with Mindy

See who holds it now, who else is bidding, and draft your response — grounded in real government data, not generic AI.

View the original notice on SAM.gov ↗

Open opportunities in NAICS 562998